6024H-T

Key Features

1. Dual Intel® 64-bit Xeon™ Support
up to 3.60 GHz

2. Up to 16GB DDR 333 SDRAM (or)
Up to 32GB DDR 266 SDRAM

3. 6 Low-Profile Expansion Slots
    2 (x8) PCI-Express,
    1 x 64-bit 133MHz PCI-X,
    2 x 64-bit 100MHz PCI-X,
    1 x 32-bit 33MHz PCI Slots

4. 2x Intel® 82541GI Single-port Gigabit
Ethernet Controllers

5. 6 x 1" Hot-swap SATA Drive Bays

6. Zero Channel RAID Support

7. 550W Power Supply


Processor/Cache

CPU	Dual 604-pin FC-mPGA4 Sockets Supports up to two Intel® Xeon™ processor(s) with 64-bit Xeon™ and 1MB L2 Integrated Advanced Transfer Cache, up to 3.60 GHz
System Bus	800 MHz system bus


System Memory

Memory Capacity	Eight 184-pin DIMM sockets Supports up to 16 GB DDR 333MHz memory, or Supports up to 32 GB DDR 266MHz memory Dual channel memory bus Memory must be populated in pairs Single-rank modules are recommended for 6+ DIMM support
Memory Type	DDR 333/266MHz buffered (registered) ECC SDRAM 72-bit, 184-pin gold-plated DIMMs
DIMM Sizes	256 MB, 512 MB, 1GB, 2GB, 4GB**
Memory Voltage	2.5 V only
Error Detection	Corrects single-bit errors Detects double-bit errors (using ECC memory) Supports Intel® x4 Single Device Data Correction (SDDC)


On-Board Devices

Chipset	Intel® E7520 chipset MCH + 6300ESB + PXH/V +82541GI
SATA	6300ESB 2-port SATA Controller RAID 0, 1, JBOD support
SATA	Marvell® 88SX6081 8-port SATA Controller RAID 0, 1, JBOD support
Zero Channel RAID	Support for Zero-Channel RAID with Adaptec 2020SA (SATA) ZCR Card: 1A, 3.3V, Low Profile 2.5" x 6.6", 400MHz I/O processor, 64MB ECC DDR memory on board [Card not included]
IPMI	Support for Intelligent Platform Management Interface v.2.0 / 1.5 (Optional)
Network Controllers	2x Intel® 82541GI Single Port Gigabit Controller Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output
Graphics	ATI Rage XL SVGA PCI video controller with 8MB of video memory
Super I/O	Winbond 83627HF chip
Clock Generator	CK409


Expansion Slots

6x low-profile expansion slots
PCI-Express	2 (x8) slot
PCI-X	1x 64-bit 133MHz PCI-X (3.3V) slot 2x 64-bit 100MHz PCI-X (3.3V) slots
PCI	1x 32-bit 33MHz PCI (5V) slot


Input / Output

Serial ATA	Ten Serial ATA ports Up to 7 SATA hard drives supported 6300ESB - 2 SATA ports Marvell 885X6081- 8 SATA ports
IDE	Dual EIDE channels support up to four UDMA IDE devices Supports UDMA Mode 5, PIO Mode 4, and ATA/100
Floppy	1 Floppy controller; 1.44 MB, 2.88 MB, 3-mode support
ZCR	Adaptec 2020SA (Card not included)
LAN	2x RJ45 LAN port
USB	2x USB rear ports 2x USB internal headers USB 2.0 Compliant / 1.1 Compliant
VGA	1x VGA port
Keyboard / Mouse	PS/2 keyboard and mouse ports
Serial Ports	2 Fast UART 16550 serial ports
Parallel Port	1 ECP/EEP parallel port 1 parallel port header


Front Panel

Buttons	• Power On/Off button • System Reset button
LEDs	• Power LED • Hard drive activity LED • 2x Network activity LEDs • System Overheat LED
Ports	none


System Cooling

Fans	4x 80mm 6300 RPM fans Cooling redundancy with fan shroud


Power Supply

2U 550W AC power supply w/ PFC [ 24-pin, (8-pin, 4-pin)=12V) ]
AC Voltage	• 100 - 240V, 50-60Hz, 9-3.5 Amp
DC Output	• 5V + 3.3V ≤ 50A
+5V	35.0 amp
+5V standby	2.0 amp
-5V	0.8 amp
+12V	42.0 amp
-12V	1.0 amp
+3.3V	30.0 amp


PC Health Monitoring

CPU	Monitors for CPU Cores, +1.8V, +3.3V, +5V, ±12V &Amp; +5V Standby
FAN	Four 4-pin fan headers Four 3-pin fan headers 8x fans with status tachometer monitoring Status monitor for speed control Status monitor for on/off control Low noise fan speed control Support 3-pin fans Pulse Width Modulated (PWM) fan connector
Temperature	Monitoring for CPU, chassis environment CPU thermal trip support Thermal control for 8x fan connectors PC temperature sensing logic Thermal Monitor 2 (TM2) support
LED	CPU / System Overheat LED Suspend-state indicator LED
Other Features	Chassis intrusion detection Chassis intrusion header SDDC Memory Sparing / Mirroring


System BIOS

BIOS Type	8Mb Flash EEPROM with Phoenix® BIOS
BIOS Features	Plug and Play (PnP) APM 1.2 DMI 2.3 PCI 2.2 ACPI 1.0 USB Keyboard support